Siemens F32812 fault code meaning
Siemens / F32812
Series: DCM-6RA80
Encoder 2: Requested clock cycle or RX/TX timing not supported
DC drive
Meaning: The cycle time or RX / TX timing requested by the control unit is not supported.
Possible causes
Source: SINAMICS DCM, Parameter Manual, firmware version 1.5 SP2 (based on 5.1 SP2) P1141
Series: G120-CU250S-2
Encoder 2: Requested cycle or RX/TX timing not supported
converter
Meaning: The cycle time or RX / TX timing requested by the control unit is not supported.
Possible causes
Source: SINAMICS G120, Control Unit CU250S-2 P1562
Series: G130-G150, S120-S150
Encoder 2: Requested clock cycle or RX/TX timing not supported
converter
Meaning: The cycle time or RX / TX timing requested by the control unit is not supported.
Possible causes
Source: SINAMICS G130_G150 P1871;SINAMICS S120_S150 P3059
Series: G220
Encoder 2: Requested cycle or RX/TX timing not supported
converter
Meaning: The cycle time or RX / TX timing requested by the converter is not supported.
Possible causes
Source: SINAMICS G220 converter P1560
Series: S110
Encoder 2: Requested cycle or RX/TX timing not supported
servo drive
Meaning: The cycle time or RX / TX timing requested by the control unit is not supported.
Possible causes
Source: SINAMICS S110 P1171
Series: S200
Encoder 2: Requested cycle or RX/TX timing not supported
servo drive
Meaning: The cycle time or RX / TX timing requested by the control unit is not supported.
Possible causes
Source: SINAMICS S200 Spindle drive P475
Series: S220
Encoder 2: Requested cycle or RX/TX timing not supported
converter
Meaning: The cycle time or RX / TX timing requested by the control unit is not supported.
Possible causes
Source: SINAMICS S220 converter P2598