Siemens F32100 fault code meaning
Siemens / F32100
Series: DCM-6RA80
Encoder 2: Zero pulse spacing error
DC drive
Meaning: The measured zero pulse spacing does not match the set zero pulse spacing. When using a distance-coded encoder, the zero pulse spacing is calculated from zero pulses detected in pairs. Therefore, a missing paired zero pulse does not trigger a fault and has no effect on the system. Set the zero pulse spacing for zero pulse monitoring in p0425 (rotary encoder) or p0424 (linear encoder).
Possible causes
Source: SINAMICS DCM, Parameter Manual, firmware version 1.5 SP2 (based on 5.1 SP2) P1108
Series: G120-CU250S-2, G130-G150
Encoder 2: Zero pulse spacing error
converter
Meaning: The measured zero pulse distance does not match the zero pulse distance setting. When a distance-coded encoder is used, the zero pulse distance is calculated from zero pulses detected in pairs. Therefore, a missing zero pulse from a pair does not trigger a fault and has no effect on the system. Set the zero pulse distance for zero pulse monitoring in p0425 (rotary encoder) or p0424 (linear encoder).
Possible causes
Source: SINAMICS G120, Control Unit CU250S-2 P1066; SINAMICS G130_G150 P1838
Series: G220
Encoder 2: Zero pulse spacing error
converter
Meaning:
Possible causes
Source: SINAMICS G220 Converter P1527
Series: S110
Encoder 2: Zero pulse spacing error
servo drive
Meaning: The measured zero pulse distance does not match the zero pulse distance setting. When a distance-coded encoder is used, the zero pulse distance is calculated from zero pulses detected in pairs. Therefore, a missing zero pulse from a pair does not trigger a fault and has no effect on the system. Set the zero pulse distance for zero pulse monitoring in p0425 (rotary encoder) or p0424 (linear encoder).
Possible causes
Source: SINAMICS S110 P1147
Series: S200
Encoder 2: Zero pulse spacing error
servo drive
Meaning: The measured zero pulse distance does not match the set zero pulse distance. When using a distance-coded encoder, the zero pulse distance is calculated from zero pulses detected in pairs. Therefore, a missing paired zero pulse does not trigger a fault and has no effect on the system. Set the zero pulse distance for zero pulse monitoring in p0425 (rotary encoder) or p0424 (linear encoder).
Possible causes
Source: SINAMICS S200 Spindle Drive P449