Siemens F30809 fault code meaning
Siemens / F30809
Series: DCM-6RA80
Power unit: Invalid switching information
DC drive
Meaning: For the 3P triggering device: The last switching status word in the setpoint telegram should be at the end marker, but no such end marker was found.
Possible causes
Source: SINAMICS DCM, Parameter Manual, firmware version 1.5 SP2 (based on 5.1 SP2) P1052
Series: G110M, G115D, G120-CU240B-E-2, G120-CU250S-2, G120D, G120X, G120XA, G130-G150, S120-S150
Power unit: Invalid switching information
converter
Meaning: For the 3P triggering device: The last switching status word in the setpoint telegram should be at the end marker, but no such end marker was found.
Possible causes
Source: SINAMICS G110M P754; SINAMICS G115D P814; SINAMICS G120, Control Unit CU240B-2_CU240E-2 P784; SINAMICS G120, Control Unit CU250S-2 P1488; SINAMICS G120D Control Unit CU240D- 2_CU250D- 2 P939; SINAMICS G120X Converter P1418; SINAMICS G120XA PN Converter P1328; SINAMICS G130_G150 P1776; SINAMICS S120_S150 P2957
Series: G120C, G210, G210X
Power unit: Invalid switching information
converter
Meaning:
Possible causes
Source: SINAMICS G120C P723; SINAMICS G210 Converter P1215; SINAMICS G210X Converter P1041
Series: G200, G220, S220
Power unit: Invalid switching information
converter
Meaning: For the 3P triggering unit: The last control status word in the setpoint telegram must be identified by a terminator, but this terminator was not detected.
Possible causes
Source: SINAMICS G200 converter P775; SINAMICS G220 converter P1471; SINAMICS S220 converter P2494
Series: S110
Power unit: Invalid switching information
servo drive
Meaning: For the 3P triggering device: The last switching status word in the setpoint telegram should be at the end marker, but no such end marker was found.
Possible causes
Source: SINAMICS S110 P1109
Series: S200
Power unit: Invalid switching information
servo drive
Meaning: For the 3P triggering unit: The last control status word in the setpoint telegram must be identified by a terminator, but this terminator was not detected.
Possible causes
Source: SINAMICS S200 PROFINET_SIMOTICS S-1FL2 P572