Siemens F30700 fault code meaning

Series: G115D

SI Motion P2: STOP A triggered

converter

Meaning: STOP A causes the drive to stop (STO is executed via the safety shutdown path of processor 1). Possible causes: - Processor 1 issued a stop request. - STO did not take effect after “Forced checking procedure” was selected. - Subsequent response to message C30711 “SI Motion P2: Error in the monitoring channel”. - Subsequent response to message C30714 “SI Motion P2: Safely-Limited Speed exceeded”.

Possible causes

Source: SINAMICS G115D P810

Series: G120-CU240B-E-2, G120-CU250S-2, G120D

SI Motion P2: STOP A triggered

converter

Meaning: STOP A stops the drive (by suppressing pulses via the safety shutdown path of processor 1). Possible causes: - Processor 1 issued a stop request. - Pulses were not suppressed after "Forced fault check" was selected. - Subsequent response to message C30706 "SI motion P2: SAM/SBR limit exceeded". - Subsequent response to message C30714 "SI motion P2: Safely-Limited Speed exceeded". - Subsequent response to message C30701 "SI motion P2: STOP B triggered".

Possible causes

Source: SINAMICS G120 Control Unit CU240B- 2_CU240E- 2 P891; SINAMICS G120 Control Units CU250S-2 P1133; SINAMICS G120D Control Unit CU240D- 2_CU250D- 2 P932

Series: S210

SI motion P2: STO triggered

servo drive

Meaning: STO stops the drive. Possible causes: - Another monitoring channel has issued a stop request. - After "Forced fault check" was selected, STO did not take effect after the set time elapsed. - Subsequent response to the following messages: A30706, A30714, F30701, A30716 Faults and alarms 15.2 Fault and alarm list SINAMICS S210 Servo Drive System Operating Instructions, 01/2019, A5E41702836F AC 529

Possible causes

Source: SINAMICS S210_SIMOTICS S-1FK2 P531