Siemens F30045 fault code meaning
Siemens / F30045
Series: DCM-6RA80
Power unit: Power supply undervoltage
DC drive
Meaning: Power supply fault in the power unit. - Voltage monitoring signals an undervoltage fault on the module. Applies to CU31x: - Voltage monitoring on the DAC board signals an undervoltage fault on the module. For S120M: - This message is displayed in the event of undervoltage or overvoltage.
Possible causes
Source: SINAMICS DCM, Parameter Manual, firmware version 1.5 SP2 (based on 5.1 SP2) P1046
Series: G120-CU250S-2, S120-S150
Power unit: Power supply undervoltage
converter
Meaning: Power supply fault in the power unit. - Voltage monitoring signals an undervoltage fault in the module. Applies to CU31x: - Voltage monitoring on the DAC board signals an undervoltage fault in the module. For S120M: - This message is displayed in the event of undervoltage or overvoltage.
Possible causes
Source: SINAMICS G120, Control Unit CU250S-2 P1466; SINAMICS S120_S150 P2898
Series: G130-G150
Power unit: Power supply undervoltage
converter
Meaning: Power supply fault in the power unit. - Voltage monitoring signals an undervoltage fault in the module. Applies to CU31x: - Voltage monitoring on the DAC board signals an undervoltage fault in the module.
Possible causes
Source: SINAMICS G130_G150 P1729
Series: G200, G210, G210X
Power unit: Power supply undervoltage
converter
Meaning:
Possible causes
Source: SINAMICS G200 converter P759; SINAMICS G210 converter P1199; SINAMICS G210X converter P1025
Series: S110
Power unit: Power supply undervoltage
servo drive
Meaning: Power supply fault in the power unit. - Voltage monitoring signals an undervoltage fault in the module. Applies to CU31x: - Voltage monitoring on the DAC board signals an undervoltage fault in the module.
Possible causes
Source: SINAMICS S110 P1083
Series: S220
Power unit: Power supply undervoltage
converter
Meaning: Power supply fault in the power unit. - Voltage monitoring signals an undervoltage fault on the module. For CU31x: - Voltage monitoring on the DAC board signals an undervoltage fault on the module. For S120M: - This message is displayed in the event of undervoltage or overvoltage.
Possible causes
Source: SINAMICS S220 converter P2471