Siemens F07517 fault code meaning
Siemens / F07517
Series: DCM-6RA80
Drive: Incorrect encoder data set changeover parameter setting
DC drive
Meaning: In at least two drive data sets (DDS), different encoder data sets (EDS) for the motor encoder have been assigned to the same motor data set (MDS). A single MDS cannot have different motor encoders in different DDS. The following settings are therefore incorrect: DDS0: p0186[0] = 0, p0187[0] = 0 DDS1: p0186[1] = 0, p0187[1] = 1
Possible causes
Source: SINAMICS DCM, Parameter Manual, firmware version 1.5 SP2 (based on 5.1 SP2) P1014
Series: G120-CU250S-2, G220, S220
Drive: Incorrect encoder data set changeover parameter setting
converter
Meaning:
Possible causes
Source: SINAMICS G120, Control Unit CU250S-2 P1396; SINAMICS G220 Converter P1351; SINAMICS S220 Converter P2321
Series: G130-G150, S120-S150
Drive: Incorrect encoder data set changeover parameter setting
converter
Meaning: In at least two drive data sets (DDS), different encoder data sets (EDS) for the motor encoder have been assigned to the same motor data set (MDS). A single MDS cannot have different motor encoders in different DDS. The following settings are therefore incorrect: DDS0: p0186[0] = 0, p0187[0] = 0 DDS1: p0186[1] = 0, p0187[1] = 1
Possible causes
Source: SINAMICS G130_G150 P1637; SINAMICS S120_S150 P2781
Series: G210
Drive: Incorrect encoder data set changeover parameter setting
converter
Meaning: In at least two drive data sets (DDS), different encoder data sets (EDS) for the motor encoder have been assigned to the same motor data set (MDS). A single MDS cannot have different motor encoders in different DDS. The following settings are therefore incorrect: DDS 0: p0186[0] = 0, p0187[0] = 0 DDS 1: p0186[1] = 0, p0187[1] = 1
Possible causes
Source: SINAMICS G210 converter P1134