Siemens F07492 fault code meaning
Siemens / F07492
Series: G120-CU250S-2
EPOS: Positive stop cam reached
converter
Meaning: A 0 signal was detected at BI: p2570, indicating that the positive stop cam has been reached. The positive stop cam was reached while running in the reverse direction, indicating an incorrect stop cam connection. See: p2570 (EPOS forward STOP cam)
Possible causes
Source: SINAMICS G120, Control Unit CU250S-2 P1391
Series: G120D
EPOS: Positive stop cam reached
converter
Meaning: A 0 signal was detected at BI: p2570, indicating that the positive stop cam has been reached. The positive stop cam was reached while moving in the negative direction, indicating an incorrect stop cam connection. See also: p2570 (EPOS Positive STOP cam)
Possible causes
Source: SINAMICS G120D Control Unit CU240D- 2_CU250D- 2 P881
Series: G130-G150
EPOS: Positive stop cam reached
converter
Meaning: A 0 signal was detected at binector input p2570, indicating that the positive stop cam has been reached. The positive stop cam was reached while moving in the negative direction, indicating incorrect stop cam connections.
Possible causes
Source: SINAMICS G130_G150 P1629
Series: G210, S220
EPOS: Positive hardware limit switch reached
converter
Meaning: A 0 signal was detected at c2570, indicating that the positive hardware limit switch has been reached. The positive hardware limit switch has been reached while the direction of travel is negative, indicating an incorrect hardware limit switch connection. See also: c2570 (EPOS positive hardware limit switch)
Possible causes
Source: SINAMICS G210 converter P1128; SINAMICS S220 converter P2313
Series: G220
EPOS: Positive hardware limit switch reached
converter
Meaning:
Possible causes
Source: SINAMICS G220 Converter P1345
Series: S110
EPOS: Positive stop cam reached
servo drive
Meaning: A 0 signal was detected at BI: p2570, indicating that the positive stop cam has been reached. The positive stop cam was reached while running in the reverse direction, indicating an incorrect stop cam connection. See: p2570 (EPOS forward STOP cam)
Possible causes
Source: SINAMICS S110 P1028
Series: S120-S150
EPOS: Positive stop cam reached
converter
Meaning: A 0 signal was detected at binary interconnection input p2570, indicating that the positive stop cam has been reached. The positive stop cam was reached while moving in the negative direction, indicating an incorrect stop cam connection. See also: p2570 (EPOS Forward STOP cam).
Possible causes
Source: SINAMICS S120_S150 P2773
Series: S200, S210
EPOS: Positive hardware limit switch reached
servo drive
Meaning: A 0 signal was detected at c2570, indicating that the positive hardware limit switch has been reached. The positive hardware limit switch has been reached while the direction of travel is negative, indicating an incorrect hardware limit switch connection. See also: c2570 (EPOS positive hardware limit switch)
Possible causes
Source: SINAMICS S200 PROFINET_SIMOTICS S-1FL2 P533; SINAMICS S210_SIMOTICS S-1FK2 and S-1FT2 P1333