Siemens F07086 fault code meaning
Siemens / F07086
Series: DCM-6RA80
Unit conversion: Parameter limits exceeded due to a change in the reference value
DC drive
Meaning: A reference parameter was changed internally in the system. As a result, the set value cannot be recalculated according to %. The parameter value is set to the minimum/maximum limit or reset to the factory setting. Possible cause: - The static or applicable minimum/maximum limit was exceeded.
Possible causes
Source: SINAMICS DCM, Parameter Manual, firmware version 1.5 SP2 (based on 5.1 SP2) P1006
Series: G110M, G120-CU240B-E-2, G120-CU250S-2, G130-G150
Unit conversion: Parameter limits exceeded due to a change in the reference value
converter
Meaning: A reference parameter was changed internally in the system. As a result, the set values cannot be recalculated according to %. The parameter values are set to the minimum/maximum limit or restored to the factory settings. Possible cause: - The static or applicable minimum/maximum limit was exceeded.
Possible causes
Source: SINAMICS G110M P704; SINAMICS G120, Control unit CU240B-2_CU240E-2 P734; SINAMICS G120, Control unit CU250S-2 P1366; SINAMICS G130_G150 P1601
Series: G115D, G120C, G120D, G120X, S120-S150
Unit conversion: Parameter limits exceeded due to a change in the reference value
converter
Meaning:
Possible causes
Source: SINAMICS G115D P761; SINAMICS G120C P677; SINAMICS G120D Control Unit CU240D- 2_CU250D- 2 P867; SINAMICS G120X Converter P1374; SINAMICS S120_S150 P2730
Series: G120XA
Unit conversion: Parameter limits exceeded due to a change in the reference value
converter
Meaning: A reference parameter was changed internally in the system. As a result, the set value cannot be recalculated according to %. The parameter value is set to the minimum/maximum limit or reset to the factory setting. Possible cause: - The static or applicable minimum/maximum limit was exceeded.
Possible causes
Source: SINAMICS G120XA PN converter P1285
Series: G200, G210X, G220
Unit change: Parameter limits exceeded due to a reference value change
converter
Meaning: Reference parameters were changed internally in the system. As a result, the values set for some parameters cannot be recalculated according to %. The parameter values are set to the minimum/maximum limits or reset to factory settings. Possible cause: - Static or applicable minimum/maximum limits exceeded.
Possible causes
Source: SINAMICS G200 converter P704; SINAMICS G210X converter P962; SINAMICS G220 converter P1317
Series: S110
Unit conversion: Parameter limits exceeded due to a change in the reference value
servo drive
Meaning: Reference parameters have been changed internally in the system. As a result, some parameter setting values cannot be written again according to % (for example, because the static or application minimum/maximum limits have been exceeded). The parameter values are set to the minimum/maximum limits or restored to factory settings.
Possible causes
Source: SINAMICS S110 P1007
Series: S200
Unit change: Parameter limits exceeded due to a reference value change
servo drive
Meaning: Reference parameters were changed internally in the system. As a result, the values set for some parameters cannot be recalculated according to %. The parameter values are set to the minimum/maximum limits or reset to factory settings. Possible cause: - Static or applicable minimum/maximum limits exceeded.
Possible causes
Source: SINAMICS S200 PROFINET_SIMOTICS S-1FL2 P513