Siemens F01911 fault code meaning
Siemens / F01911
Series: DCM-6RA80
PB/PN: Isochronous synchronization cycle fault
DC drive
Meaning: During cyclic operation, errors in the global control telegram used for cycle synchronization, or violations of the time unit specified by the configuration telegram (see bus cycle Tdp and Tpllw), have persisted for several DP cycles.
Possible causes
Source: SINAMICS DCM, Parameter Manual, firmware version 1.5 SP2 (based on 5.1 SP2) P982
Series: G120-CU250S-2
PB/PN Isochronous synchronization cycle fault
converter
Meaning: During cyclic operation, errors occurred in the global control telegram used to synchronize the cycle, or the time unit specified in the configuration telegram was exceeded (see bus cycle Tdp and Tpllw). These errors persisted for several DP cycles.
Possible causes
Source: SINAMICS G120, Control Unit CU250S-2 P1338
Series: G130-G150
PROFIBUS: Clock synchronous operation, clock cycle
converter
Meaning:
Possible causes
Source: G150 P841
Series: G200, G210X, G220
PN: Cycle fault during isochronous synchronous run
converter
Meaning: The telegram for cycle synchronization failed during several consecutive bus cycles or arrived outside the specified time window during several consecutive bus cycles (see bus cycle Tdp and Tpllw).
Possible causes
Source: SINAMICS G200 converter P683; SINAMICS G210X converter P937; SINAMICS G220 converter P1282
Series: S110
PB/PN Isochronous synchronization cycle fault
servo drive
Meaning: During cyclic operation, the global control telegram used to synchronize the cycles is faulty, or the time unit specified by the configuration telegram has been exceeded (see bus cycle Tdp and Tpllw). These errors have persisted for several DP cycles.
Possible causes
Source: SINAMICS S110 P988
Series: S200, S210
PN: Cycle fault during isochronous synchronous run
servo drive
Meaning: The telegram for cycle synchronization failed during several consecutive bus cycles or arrived outside the specified time window during several consecutive bus cycles (see bus cycle Tdp and Tpllw).
Possible causes
Source: SINAMICS S200 PROFINET_SIMOTICS S-1FL2 P499; SINAMICS S210_SIMOTICS S-1FK2 and S-1FT2 P1310
Series: S220
PN: Cycle fault during isochronous synchronous run
converter
Meaning:
Possible causes
Source: SINAMICS S220 Converter P2190