Siemens F01070 fault code meaning

Series: G130-G150, S120-S150

Project/firmware download to the memory card in progress

converter

Meaning: An upgrade process (project/firmware download) has been triggered on the memory card. While this fault is present, the corresponding upgrade and plausibility and consistency checks are performed. Depending on the selected command, the control unit is then restarted (reset). Caution: The control unit must not be switched off while the upgrade is in progress and this fault is present. An interruption will damage the file system on the memory card. The memory card will then be unable to function normally and must be repaired.

Possible causes

Source: SINAMICS G130_G150 P1443; SINAMICS S120_S150 P2519

Series: S210

Project/firmware download to the storage card in progress

servo drive

Meaning: An upgrade process was triggered on the memory card (project/firmware download). While this fault is present, the corresponding upgrade and plausibility and consistency checks are performed. Depending on the selected command, a restart (reset) of the control unit is then triggered. Caution: The control unit must not be switched off while the upgrade is in progress and this fault is present. Interruption of the operation will damage the file system on the memory card. The memory card will then no longer function normally and must be repaired.

Possible causes

Source: SINAMICS S210_SIMOTICS S-1FK2 and S-1FT2 P1266