Siemens F01033 fault code meaning
Siemens / F01033
Series: DCM-6RA80
Unit conversion: Reference parameter invalid
DC drive
Meaning: When converting to a relative system of units, the required reference parameter must not equal 0.0.
Possible causes
Source: SINAMICS DCM, Parameter Manual, firmware version 1.5 SP2 (based on 5.1 SP2) P929
Series: G110M, G130-G150
Unit conversion: Reference parameter invalid
converter
Meaning:
Possible causes
Source: SINAMICS G110M P666;SINAMICS G130_G150 P1432
Series: G115D, G120-CU240B-E-2, G120-CU250S-2, G120C, G120D, G120X, G120XA, S120-S150
Unit conversion: Reference parameter invalid
converter
Meaning: When converting to a relative system of units, the required reference parameter must not equal 0.0.
Possible causes
Source: SINAMICS G115D P714; SINAMICS G120, Control Unit CU240B-2_CU240E-2 P691; SINAMICS G120, Control Unit CU250S-2 P1276; SINAMICS G120C P641; SINAMICS G120D Control Unit CU240D- 2_CU250D- 2 P818; SINAMICS G120X converter P1349; SINAMICS G120XA PN converter P1264; SINAMICS S120_S150 P2508
Series: G120-CU230P-2
Unit changeover: Reference parameter value invalid. Set the reference parameter to a value other than 0.0 (p0304, p0305, p03
converter
Meaning:
Possible causes
Source: Converter SINAMICS G120, equipped with control unit CU230P-2 P490
Series: G120P-Cabinet
Unit switching: Reference parameter value
converter
Meaning:
Possible causes
Source: SINAMICS G120P Cabinet P509
Series: G200, G210, G210X, G220
Unit switching: Reference parameter invalid
converter
Meaning: When switching to percentage units, the required reference parameters must not equal 0.0.
Possible causes
Source: SINAMICS G200 Basic Converter P481; SINAMICS G210 Converter P978; SINAMICS G210X Converter P846; SINAMICS G220 Converter P1180
Series: S110, S210
Unit conversion: Reference parameter invalid
servo drive
Meaning: When converting to a relative system of units, the required reference parameter must not equal 0.0.
Possible causes
Source: SINAMICS S110 P925; SINAMICS S210_SIMOTICS S-1FK2 and S-1FT2 P832
Series: S200
Unit switching: Reference parameter invalid
servo drive
Meaning: When switching to percentage units, the required reference parameters must not equal 0.0.
Possible causes
Source: SINAMICS S200 PROFINET_SIMOTICS S-1FL2 P449
Series: S220
Unit switching: Reference parameter invalid
converter
Meaning:
Possible causes
Source: SINAMICS S220 Converter P2056