Siemens A07200 fault code meaning
Siemens / A07200
Series: DCM-6RA80
Drive: Master control issues ON command
DC drive
Meaning: The ON/OFF1 command (not the 0 signal) is present. This command can be issued via BI p0840 (currently CDS) or master control word bit 0.
Possible causes
Source: SINAMICS DCM, Parameter Manual, firmware version 1.5 SP2 (based on 5.1 SP2) P1008
Series: G110M, G120-CU240B-E-2, G120-CU250S-2, G130-G150, S120-S150
Drive: Master control issues ON command
converter
Meaning: The ON/OFF1 command (not the 0 signal) is present. This command can be issued via BI p0840 (currently CDS) or master control word bit 0.
Possible causes
Source: SINAMICS G110M P705; SINAMICS G120, Control Unit CU240B-2_CU240E-2 P735; SINAMICS G120, Control Unit CU250S-2 P1368; SINAMICS G130_G150 P1603; SINAMICS S120_S150 P2735
Series: G115D, G120C, G120D
Drive: Master control issues ON command
converter
Meaning:
Possible causes
Source: SINAMICS G115D P762;SINAMICS G120C P678;SINAMICS G120D Control Unit CU240D- 2_CU250D- 2 P868
Series: G120X, G120XA
Drive: Master control issues ON command
converter
Meaning: The ON/OFF1 command (not the 0 signal) is present. This command can be issued via BI p0840 (currently CDS) or master control word bit 0.
Possible causes
Source: SINAMICS G120X Converter P1375; SINAMICS G120XA PN Converter P1286
Series: G200, G210, G210X, G220, S220
Drive: Master control issues ON command
converter
Meaning: The ON/OFF1 command is set (not the 0 signal). This command can be controlled via binary signal sink c0840 (currently CDS) or master control word bit 0.
Possible causes
Source: SINAMICS G200 Converter P705; SINAMICS G210 Converter P1101; SINAMICS G210X Converter P963; SINAMICS G220 Converter P1318; SINAMICS S220 Converter P2268
Series: S110
Drive: Master control issues ON command
servo drive
Meaning: The ON/OFF1 command (not the 0 signal) is present. This command can be issued via BI p0840 (currently CDS) or master control word bit 0.
Possible causes
Source: SINAMICS S110 P1009
Series: S200
Drive: Master control issues ON command
servo drive
Meaning: The ON/OFF1 command is set (not the 0 signal). This command can be controlled via control word bit 0 for master control.
Possible causes
Source: SINAMICS S200 PROFINET_SIMOTICS S-1FL2 P516
Series: S210
Drive: Master control issues ON command
servo drive
Meaning: The ON/OFF1 command is present (not the 0 signal). This command can be controlled via binary signal sink c0840 (currently CDS) or control word bit 0 of the master control.
Possible causes
Source: SINAMICS S210_SIMOTICS S-1FK2 and S-1FT2 P1318