Siemens A07094 fault code meaning
Siemens / A07094
Series: DCM-6RA80
Common parameters out of range
DC drive
Meaning: The parameter value was auto-corrected because the parameter limits were exceeded. Minimum limit exceeded --> the parameter is set to the minimum value. Maximum limit exceeded --> the parameter is set to the maximum value.
Possible causes
Source: SINAMICS DCM, Parameter Manual, firmware version 1.5 SP2 (based on 5.1 SP2) P1007
Series: G110M, G115D, G120-CU240B-E-2, G120C, G120D, G120X
Common parameters out of range
converter
Meaning: The parameter value was auto-corrected because the parameter limits were exceeded. Minimum limit exceeded --> the parameter is set to the minimum value. Maximum limit exceeded --> the parameter is set to the maximum value.
Possible causes
Source: SINAMICS G110M P704; SINAMICS G115D P762; SINAMICS G120 Control Unit CU240B- 2_CU240E- 2 P840; SINAMICS G120C P678; SINAMICS G120D Control Unit CU240D- 2_CU250D- 2 P868; SINAMICS G120X Converter P1375
Series: G120-CU250S-2
Common out-of-range conditions
converter
Meaning: The parameter value was auto-corrected because the parameter limits were exceeded. Minimum limit exceeded --> the parameter is set to the minimum value. Maximum limit exceeded --> the parameter is set to the maximum value.
Possible causes
Source: SINAMICS G120, Control Unit CU250S-2 P1014
Series: G120XA, G130-G150
Common parameters out of range
converter
Meaning:
Possible causes
Source: SINAMICS G120XA PN converter P1285; SINAMICS G130_G150 P1602
Series: S210
Common parameters out of range
servo drive
Meaning: The parameter value was auto-corrected because the parameter limits were exceeded. Minimum limit exceeded --> the parameter is set to the minimum value. Maximum limit exceeded --> the parameter is set to the maximum value.
Possible causes
Source: SINAMICS S210_SIMOTICS S-1FK2 P500