Siemens A03510 fault code meaning
Siemens / A03510
Series: DCM-6RA80
TM: Implausible calibration data
DC drive
Meaning: At start, the calibration data of terminal module 31(TM31) is read and checked for plausibility. At least one invalid calibration data value was detected.
Possible causes
Source: SINAMICS DCM, Parameter Manual, firmware version 1.5 SP2 (based on 5.1 SP2) P1004
Series: G110M
Implausible calibration data
converter
Meaning:
Possible causes
Source: SINAMICS G110M P697
Series: G115D, G120-CU240B-E-2, G120C, G120D, G120X, G120XA
Implausible calibration data
converter
Meaning: At start, the calibration data for the analog inputs is read and checked for plausibility. At least one calibration data value was detected as invalid.
Possible causes
Source: SINAMICS G115D P754; SINAMICS G120, Control Unit CU240B-2_CU240E-2 P728; SINAMICS G120C P672; SINAMICS G120D Control Unit CU240D- 2_CU250D- 2 P862; SINAMICS G120X Converter P1368; SINAMICS G120XA PN Converter P1279
Series: G120-CU250S-2, G130-G150
TM: Implausible calibration data
converter
Meaning: At start, the calibration data of terminal module 31(TM31) are read and checked for plausibility. At least one calibration data value was detected as invalid.
Possible causes
Source: SINAMICS G120, Control Unit CU250S-2 P1354; SINAMICS G130_G150 P1581
Series: G200, G210X, G220
Implausible calibration data
converter
Meaning: At start, the calibration data for the analog inputs is read and checked for plausibility. At least one invalid calibration data value has been detected.
Possible causes
Source: SINAMICS G200 converter P699; SINAMICS G210X converter P955; SINAMICS G220 converter P1299
Series: S110
TM: Implausible calibration data
servo drive
Meaning: At start, the calibration data of terminal module 31(TM31) are read and checked for plausibility. At least one calibration data value was detected as invalid.
Possible causes
Source: SINAMICS S110 P1002
Series: S120-S150
CU: Implausible calibration data
converter
Meaning: At start, the calibration data of terminal module 31(TM31) are read and checked for plausibility. At least one calibration data value was detected as invalid.
Possible causes
Source: SINAMICS S120_S150 P2691