Siemens A02100 fault code meaning
Siemens / A02100
Series: DCM-6RA80
Drive: Current loop computation dead time too short
DC drive
Meaning: The value in p0118 causes a delay of one cycle because it occurs before the setpoint is available. Possible causes: - A parameter backup file from a version later than 4.3 was loaded into a version earlier than or equal to 4.3. - After component replacement, the device properties and parameter settings no longer match.
Possible causes
Source: SINAMICS DCM, Parameter Manual, firmware version 1.5 SP2 (based on 5.1 SP2) P999
Series: G120-CU250S-2
Drive: Current loop computation dead time too short
converter
Meaning: The value in p0118 causes a delay of one cycle because it occurs before the setpoint is available. Possible causes: - A parameter backup file from a version higher than 4.3 was loaded into a version lower than or equal to 4.3. - After a component replacement, the device properties no longer match the parameter settings.
Possible causes
Source: SINAMICS G120, Control Unit CU250S-2 P1351
Series: G130-G150
CU: Computation deadtime current controller too sh
converter
Meaning:
Possible causes
Source: G150 P850
Series: S110
Drive: Current loop computation dead time too short
servo drive
Meaning: The value in p0118 causes a delay of one cycle because it occurs before the setpoint is available. Possible causes: - A parameter backup file from a version higher than 4.3 was loaded into a version lower than or equal to 4.3. - After a component replacement, the device properties no longer match the parameter settings.
Possible causes
Source: SINAMICS S110 P999
Series: S120-S150
Drive: Current loop computation dead time too short
converter
Meaning:
Possible causes
Source: SINAMICS S120_S150 P2683