Siemens A02060 fault code meaning
Siemens / A02060
Series: DCM-6RA80
Trace: No signals specified for recording
DC drive
Meaning: No signals to be recorded have been specified. - The specified signals are invalid. See also: p4730 (trace signal to be recorded 0), p4731 (trace signal to be recorded 1), p4732 (trace signal to be recorded 2), p4733 (trace signal to be recorded 3)
Possible causes
Source: SINAMICS DCM, Parameter Manual, firmware version 1.5 SP2 (based on 5.1 SP2) P995
Series: G110M, G115D, G120-CU240B-E-2, G120-CU250S-2, G120C, G120D, G200, G210, G210X, G220, S220
Trace: No signals specified for recording
converter
Meaning: No signal to be recorded has been specified. - The specified signal is invalid.
Possible causes
Source: SINAMICS G110M P693; SINAMICS G115D P750; SINAMICS G120, Control Unit CU240B-2_CU240E-2 P724; SINAMICS G120, Control Unit CU250S-2 P1349; SINAMICS G120C P668; SINAMICS G120D Control Unit CU240D- 2_CU250D- 2 P858; SINAMICS G200 Converter P694; SINAMICS G210 Converter P1086; SINAMICS G210X Converter P949; SINAMICS G220 Converter P1293; SINAMICS S220 Converter P2205
Series: G120X
Trace: No signals specified for recording
converter
Meaning: No signals to be recorded have been specified. - The specified signals are invalid. See also: p4730, p4731, p4732, p4733
Possible causes
Source: SINAMICS G120X Converter P1364
Series: G130-G150, S120-S150
Trace: No signals specified for recording
converter
Meaning: No signal to be recorded has been specified. - The specified signal is invalid. See also: p4730 (Trace signal to be recorded 0), p4731 (Trace signal to be recorded 1), p4732 (Trace signal to be recorded 2), p4733 (Trace signal to be recorded 3)
Possible causes
Source: SINAMICS G130_G150 P1570;SINAMICS S120_S150 P2680
Series: S110
Trace: No signals specified for recording
servo drive
Meaning: No signal to be recorded is specified. - The specified signal is invalid. See: p4730 (Trace signal to be recorded 0), p4731 (Trace signal to be recorded 1), p4732 (Trace signal to be recorded 2), p4733 (Trace signal to be recorded 3).
Possible causes
Source: SINAMICS S110 P998
Series: S200
Trace: No signals specified for recording
servo drive
Meaning: No signal to be recorded has been specified. - The specified signal is invalid.
Possible causes
Source: SINAMICS S200 Compact_SIMOTICS S-1FL2 and S-1FL1 P480