Siemens A02040 fault code meaning

Siemens / A02040

Series: DCM-6RA80

Function generator: Incorrect offset value

DC drive

Meaning: The offset value is above the upper limit or below the lower limit. See also: p4826 (Function generator offset).

Possible causes

Source: SINAMICS DCM, Parameter Manual, firmware version 1.5 SP2 (based on 5.1 SP2) P992

Series: G120-CU250S-2

Function generator: Incorrect offset value

converter

Meaning: The offset value is greater than the upper limit or less than the lower limit. See: p4826 (Function generator offset).

Possible causes

Source: SINAMICS G120, Control Unit CU250S-2 P1347

Series: G130-G150, S120-S150

Function generator: Incorrect offset value

converter

Meaning: The offset value is greater than the upper limit or less than the lower limit. See also: p4826 (Function generator offset)

Possible causes

Source: SINAMICS G130_G150 P1567;SINAMICS S120_S150 P2677

Series: G200, G210X, G220, S220

Function generator: Incorrect offset value

converter

Meaning: The offset value is above the upper limit or below the lower limit.

Possible causes

Source: SINAMICS G200 converter P692; SINAMICS G210X converter P947; SINAMICS G220 converter P1291; SINAMICS S220 converter P2203

Series: G210

Function generator: Incorrect offset value

converter

Meaning: The offset value is above the upper limit or below the lower limit. Faults and alarms 5.2 Fault and alarm list SINAMICS G210 Converter 1082 Parameter Manual, 07/2026, FW V6.7, A5E54375461F AA

Possible causes

Source: SINAMICS G210 converter P1084

Series: S110

Function generator: Incorrect offset value

servo drive

Meaning: The offset value is greater than the upper limit or less than the lower limit. See: p4826 (Function generator offset).

Possible causes

Source: SINAMICS S110 P996

Series: S200

Function generator: Incorrect offset value

servo drive

Meaning:

Possible causes

Source: SINAMICS S200 PROFINET_SIMOTICS S-1FL2 P504