Siemens A01016 fault code meaning
Siemens / A01016
Series: DCM-6RA80
Firmware modified
DC drive
Meaning: At least one firmware file in non-volatile memory (memory card/device memory) has been modified without authorization and differs from its factory state.
Possible causes
Source: SINAMICS DCM, Parameter Manual, Firmware Version 1.5 SP2 (based on 5.1 SP2) P926
Series: G110M, G115D, G120-CU250S-2, G120C, G120D, G130-G150, S120-S150
Firmware modified
converter
Meaning: At least one firmware file in nonvolatile memory (memory card/device memory) has been modified without authorization and differs from its factory state.
Possible causes
Source: SINAMICS G110M P664; SINAMICS G115D P711; SINAMICS G120, control unit CU250S-2 P898; SINAMICS G120C P639; SINAMICS G120D control unit CU240D- 2_CU250D- 2 P816; SINAMICS G130_G150 P1430; SINAMICS S120_S150 P2505
Series: G120-CU240B-E-2
Firmware modified
converter
Meaning: The factory settings of at least one firmware file in directory /SIEMENS/SINAMICS/ have been changed. Changes to this directory are not permitted. Warning value (r2124, decimal): 0: File checksum error. 1: File missing. 2: Too many files. 3: Incorrect firmware version. 4: Backup file checksum error. See: r9925 (Firmware file error).
Possible causes
Source: SINAMICS G120 Control Unit CU240B_E-2 P637
Series: G120X, G120XA
Firmware modified
converter
Meaning: At least one firmware file in non-volatile memory (memory card/device memory) has been modified without authorization and differs from its factory state.
Possible causes
Source: SINAMICS G120X converter P1347; SINAMICS G120XA PN converter P1262
Series: S110
Firmware modified
servo drive
Meaning: The factory settings of at least one firmware file in directory /SIEMENS/SINAMICS/ have been changed. Changes to this directory are not permitted.
Possible causes
Source: SINAMICS S110 P923
Series: S210
Firmware modified
servo drive
Meaning: At least one firmware file in non-volatile memory (memory card/device memory) has been modified without authorization and differs from its factory state.
Possible causes
Source: SINAMICS S210_SIMOTICS S-1FK2 P445