Inovance 10-1 fault code meaning

Series: MD580

AC drive

Meaning: Fault category: drive overload; Default level: coast stop; Reset method: manual reset

Source: Inovance Official Function Manual 19011555 A00 P450

AC drive

Meaning:

Load too large
Selected drive is undersized
Model parameter setting error
Motor parameter setting error
When the control mode is V/f, the torque boost setting is inappropriate.
Motor locked rotor
The overload mode [A4-51] selection is inappropriate.
Derating caused by an excessively high carrier frequency setting
Derating caused by prolonged operation at low frequency
Unstable operation near 0Hz in SVC control
Control mode is FVC or SVC, and the synchronous motor is demagnetized
Control mode is FVC or SVC, and motor parameters have not been identified
Acceleration/deceleration time too short in V/f control
V/f curve reference voltage too large in V/f control
Direct start while the motor is still rotating
When the control mode is V/f, oscillation causes overload.
When the control mode is FVC or SVC, synchronous motor magnetic pole angle identification is incorrect.
Control mode is FVC, and encoder parameter settings are inappropriate
Control mode is FVC, and encoder wiring has an error
Control mode is FVC, and the encoder-related parameters have not been identified
Control mode is FVC, and there is a problem with encoder installation
Control mode is FVC, and the synchronous motor position changes after stop
Other causes

Source: MD580S Series Low-Voltage High-Performance Engineering AC Drive Function Manual P419; MD880 Series AC Drive Function Manual (HCU) P602

braking unit

Meaning:

Source: MD880-61 Series Single-Phase Braking Unit Parameter Manual P48