BALDOR 7 fault code meaning

BALDOR / 7

Series: BSC1000/1100

Monitor 7

servo drive

Meaning: I2T warning. After 2-3 seconds, control switches off then monitor displays "6"

Possible causes

Source: BALDOR BSC1000/1100 Servo Control Manual MN1202 Table 5-1 Status and Fault Indications

Series: BSC2000/3000

Monitor 7

servo drive

Meaning: I²t-Limit | If I²t-limit is reached, amplifier will reduce output current to its nominal value. After 1.5s ±0.5s BSC switches off with fault indication "6; electronic fusing" | Cycle time between motor acceleration and deceleration is too short.

Possible causes

Source: BALDOR BSC2000/3000 Servo Control Manual 7.0 Status Monitor P23

Series: DBTS10 R/RL

I²t limit (warning)

servo drive

Meaning: If I²t-limit is reached, amplifier will reduce output current to it's nominal value. After 2.5s ±0.5s DBTS switches off (amplifier disable) with fault indication "6; electronic fusing" Remedy: Cycle time between motor acceleration and deceleration is too short.

Possible causes

Source: