Xinling fault codes

Fault codes

A-09 Drive overload pre-alarm
A-17 RS485 communication fault pre-alarm
A-18 PID feedback open alarm
A-21 EEPROM read/write pre-alarm
A-23 PID feedback loss pre-alarm
A-24 Run limit pre-alarm
E-0.1 Inverter overheat
E-0.2 Pulse overcurrent
E-0.3 Inverter overcurrent
E-0.4 Inverter overload
E-0.8 Inverter limit overload
E-01 Inverter unit fault
E-02 Acceleration overcurrent
E-03 Deceleration overcurrent
E-04 Deceleration during operation
E-05 Acceleration overcurrent during operation
E-06 Constant speed overvoltage during operation
E-07 DC bus undervoltage
E-08 Motor overload
E-09 Inverter overload
E-1.0 Overvoltage
E-11 Power module fault
E-12 Input phase loss
E-13 Output phase loss or current imbalance
E-14 Heatsink overheat 1
E-15 Heatsink overheat 2
E-16 External device fault
E-17 RS485 communication error
E-18 Keypad communication error
E-19 Current detection fault
E-20 Motor tuning fault
E-21 EEPROM read/write error
E-22 Parameter copy error
E-23 PID feedback open
E-24 Run time limit reached
E-25 Output ground fault
E-26 PG open
E-27 Excessive speed deviation fault
E-28 Overspeed
E-29 Cumulative power-on time reached fault
E-30 Load loss fault
E-31 PID feedback loss fault during operation
E-40 Cycle-by-cycle current limit fault
E-51 Initial position fault
E.485 Communication error
E.EF External fault
E.END Run time reached
E.ILF Input phase loss
E.OLF Output phase loss
E.PIDE PID feedback open
E.bC Braking unit fault
E01 Cycle-by-cycle current limit escalated to fault
E02 Acceleration overcurrent
E03 Deceleration overcurrent
E04 Constant speed overcurrent
E05 Acceleration overvoltage
E06 Deceleration overvoltage
E07 Constant speed overvoltage
E10 Inverter overload
E11 Motor overload
E12 Input phase loss
E13 Output phase loss imbalance
E14 Module overheat
E15 External fault
E16 Communication error
E17 Contactor fault
E18 Current detection fault
E19 Motor tuning fault
E20 EEPORM parameter read/write error
E22 Motor ground fault
E23 Run time reached
E25 User-defined fault
E26 Power-on time reached
E28 PID feedback loss during operation
E29 Excessive speed deviation F8-5
E42 Temperature sensor fault
E44 Pipe overpressure protection
Err13 Start time too long