Kinco fault codes
Fault codes
- 000.1 Expansion fault
- 000.2 Encoder ABZ signal error (incremental) / encoder communication error (magnetic)
- 000.4 Encoder UVW signal error (incremental) / encoder internal error (magnetic)
- 000.8 Encoder count error (incremental) / encoder CRC error (magnetic)
- 001.0 Drive overtemperature
- 002.0 Drive bus voltage too high
- 004.0 Drive bus voltage too low
- 008.0 Drive output short circuit
- 010.0 Drive braking resistor fault
- 020.0 Actual tracking error exceeded allowance
- 040.0 Logic voltage too low
- 080.0 Motor or drive IIT fault
- 100.0 Input pulse frequency too high
- 200.0 Motor overtemperature
- 400.0 Motor excitation error (incremental encoder) / encoder info error (magnetoelectric encoder)
- 800.0 EEPROM data error
- E0001 Acceleration overcurrent
- E0002 Deceleration overcurrent
- E0003 Constant speed overcurrent
- E0004 Acceleration overvoltage
- E0005 Deceleration overvoltage
- E0006 Constant speed overvoltage
- E0007 Undervoltage
- E0008 FO fault
- E0009 Output phase-to-phase short circuit
- E0010 Ground fault
- E0011 Current detection fault
- E0012 Cycle-by-cycle current limit fault
- E0013 Motor tuning fault
- E0014 Input phase loss
- E0015 Output phase loss
- E0018 Soft-charge resistor overload
- E0023 Inverter overload
- E0024 Motor overload
- E0025 Load loss fault
- E0026 Module overheat
- E0027 Motor overtemperature
- E0028 External device fault
- E0029 Communication error
- E0030 EEPROM read/write error
- E0031 PID feedback loss fault during operation
- E0032 Cumulative run time reached fault
- E0033 Cumulative power-on time reached fault
- E0034 User-defined fault
- E0039 KEY or main contactor fault
- E0040 Encoder fault
- E0041 Excessive speed deviation fault
- E0042 Motor overspeed
- E0043 SVC stall fault
- E0050 Synchronous motor SVC initial position fault
- E0060 Synchronous motor back-EMF fault
- E0070 Pump-up drive overcurrent
- E0071 Pump-up drive current detection fault
- E0072 Pump-up drive current detection fault
- E0073 Pump-up drive overload
- E0074 Pump-up motor overload
- E0075 Pump-up overvoltage
- FFF.F Not configuration motor/motor configuration incorrect